Dodge Neon 2001, Руководство по обслуживанию

Страница: 529 / 743

(8) Install ring gear to differential case. Install
new bolts and torque to 81 N·m (60 ft. lbs.) torque
(Fig. 29).
Measure and Adjust Side Gear End-Play
(1) Rotate the assembly two full revolutions both
clockwise and counterclockwise.Set up dial indicator
as shown and record end play (Fig. 30) (Fig. 31).
Rotate side gear 90 degrees and take another mea-
surement. Again, rotate side gear 90 degrees and
record a final measurement.
(2) Using the smallest end play recorded, shim
that side gear to within 0.001 to 0.013 inch. The
other side gear should be checked using the same
procedure.
CAUTION: Side gear end play must be within 0.001
to 0.013 inch. Five select thrust washers are avail-
able: 0.027, 0.032, 0.037, 0.042, and 0.047 inch.
Fig. 28 Drive Gear Pressed onto Differential
1 - PRESS RAM
2 - SPEEDOMETER DRIVE GEAR
3 - DIFFERENTIAL ASSEMBLY
Fig. 29 Install Ring Gear and Bolts
1 - SPEEDOMETER DRIVE GEAR
2 - BEARING
3 - RING GEAR
4 - RING GEAR BOLTS
Fig. 30 Checking Side Gear End Play (Typical)
1 - SPECIAL TOOL C-4996 (NOTE POSITION)
2 - DIAL INDICATOR SET
3 - DIFFERENTIAL ASSEMBLY
4 - SIDE GEAR
Fig. 31 Checking Side Gear End Play—Typical
1 - SPECIAL TOOL C-4996 (NOTE POSITION)
2 - DIAL INDICATOR SET
3 - DIFFERENTIAL ASSEMBLY
21s - 14 A578 MANUAL TRANSMISSION
PL
DIFFERENTIAL (Continued)
ProCarManuals.com
2001 NEON