Docomo style L-10C, Инструкция по эксплуатации

Страница: 136 / 150

26
AT Commands
AT commands are used to check the FOMA terminal function settings or status on a PC.
Usually the communication software issues AT commands so that you do not have to be
aware of them. Use AT commands if you want to control the FOMA terminal in your own way.
Format of AT Commands
AT commands should be entered on the Terminal Mode screen of the communication software
such as Hyper Terminal.
• Terminal Mode is for sending text input on a PC to the line connected to the communication port.
Example of Entry Format
ATD * 99***1#
Hard Return
Parameter: Content of the command.
Command Name
• An AT command must be entered on a single line including parameters (numbers and symbols)
following the command. On the Terminal Mode screen of the communication software, "one line" is
from the first character to the character prior to .
You can enter up to 256 characters including the AT command.
• Be sure to enter half-pitch alphanumeric characters for the AT command, including any parameters
that follow the command.
• If the entered characters do not appear, enter ATE 。
AT Command List
The following commands can be used with the L-10C modem.
• The following commands can be entered but are invalid commands that will not work.
- AT (input only AT)
- ATS0 (set number of rings until the FOMA terminal automatically answers a call)
- ATS6 (set time for pause until dialing)
- ATS8 (set time for pause by comma dial)
- ATS10 (set time for delay until automatic disconnection)
AT Commands Overview Parameters/Descriptions
Command
Examples
A/ Repeat the last AT
command executed. A
carriage return (CR) does
not need to be entered
after inputting this
command.
－ A/
OK
AT%V Display the version of the
FOMA terminal. － AT%V
L10C-
MSM1350-
VXXX-XXX-XX-
XXXX-DCM-JP
X [XXX XX
2011 XX:XX:XX]
OK