Docomo P-04B, Инструкция по эксплуатации

Страница: 129 / 162

19
This section explains how to set up a connection for packet communication without using “DOCOMO
Connection Manager”.
The packet communication uses AT commands to carry out the settings from a personal computer. To
specify settings, communication software to enter AT command is required. “Hyper Terminal”, which is
attached to Windows as the standard software, is used here for explanation.
When using DOCOMO Internet access service “mopera U” or “mopera”, you do not need to set an access
point name (APN) (see page 22).
You can set “caller ID notified/not notified” (see page 25) as required. (You need to set “caller ID notified”
when using “mopera U” or “mopera”.)
≥
Windows 7 and Windows Vista do not support “Hyper Terminal”. For these operating systems, use a software program which supports
Windows 7 or Windows Vista for setting up the connection. (Follow the settings of the software program used.)
<Packet communication setting flow using AT commands>
Setting Dial-up Network
Set Packet Communication
Confirm the COM port number (See page 20)
Start the communication software that enables the entry of AT commands (See step 3 on page 22)
Set an access point name (APN) (See step 7 on page 23)
Set “caller ID notified/not notified” (See step 2 on page 25)
Set others (See page 37)
Exit the communication software (See step 9 on page 24)
■ AT commands
≥
The AT commands are used to control a modem. The FOMA terminal, which conforms to the AT commands, supports some extended
commands and unique AT commands.
≥ By entering AT commands, you can carry out detailed setting for packet communication and FOMA terminal, and confirm (display) the
setting contents.
≥
If the entered AT command is not displayed, enter “ATE1 ”.