Dobot MOOZ-2 PLUS, Руководство по эксплуатации

Страница: 13 / 30

10
Warning:
2.5 Offline Printing
Note:
2.
Make sure the machine has been properly leveled and zeroed before executing any Gcode files.
1.
The U disk format shall be Fat32 with the capacity not greater than 32GB.
3.
Applying gummed textured paper before printing can greatly reduce risk of getting the heated bed sticker scratched!
Operation steps:
2.Follow the steps below to execute the Gcode file.
1.Preheat nozzle and heated bed to target temperature, and test extrusion performance of the 3D print functional module.
2. After printing finished, please wait until heated bed cools down to ambient temperature, then bend the flexible gasket slightly to remove the print .
1.
After printing started, please make sure the first layer is in good bonding condition, and sort out the filament before leaving. Loose bonding may cause falling off of the
model, and result in clogging of the print head. “Raft” build plate adhesion type is suggested for better bonding and easy removal of finished model.
Enter the File interface
Click print button
to start printing
Wait for the heatbed
and nozzle to reach
the target temperature
Start printing
automatically
Select the file
you want to print