DoAll C-8056SA, Инструкция по эксплуатации

Страница: 25 / 26

23
7. MACHINE TROUBLE SHOOTING
During operation, the machine may fail in operation due to personal or other factors. At this time,
the trouble must be solved as shown below:
SA Series
No. ERROR MESSAGE CORRECTION
1 Hydraulic system does not start
1. Release the EMERGENCY STOP
2. Check if the electric overload
2 Saw blade does not start
1. Check if the clamping indicating lamp
lights on.
2. Check if blade stalling or breakage
3. Check the overload relay
4. Check the electrical line
3 Saw bow does not move upward Check if the limit switch damaged
4 Saw bow does not move downward
1. Check if chip jam under the guide
holder
2. Check if the solenoid valve of lifting
cylinder damaged
5 Cutting fluid abnormal
1. Check the amount of coolant tank
2. Check if the line clogged
3. Check if the pump damaged
4. Check the electrical line
6 Vise does not move
1. Check connection of the line
2. Check if the solenoid valve damaged
7 Seriously noisy when cutting
1. Adjust touching situation of blade and
the wheel edge
2. Check if guide holder damaged
3. Check if the upper tungsten insert or
bearing damaged or improper
touching with the blade
4. Check if the bearing of driven wheel
damaged.
5. Check if the bearing in gear box
damaged or bad lubrication