DoAll C-8056SA, Инструкция по эксплуатации

Страница: 21 / 26

19
EVERY THREE MONTHS
1. Replace the oil in spindle gearbox.
(Replace oil after initial 3 months, then, every 6 months)
※
Suggested gear oil: SAE 90 (ISO 220)
2. Check all lock screws. Tighten them if necessary.
3. Check main drive belt tension.
4. Check steel brush belt tension.
YEARLY
Replace oil in hydraulic oil tank.
(Suggested hydraulic oil: ISO-VG grade No.32)
6.3.1 CHANGE OIL IN GEARBOX
Remove the plug at the bottom of the oil tank. Place a container under the gearbox for collecting
the used oil. Wrap tape seal around the plug then tighten it securely. Fill oil through the oil inlet
port located at the top of the gearbox until the oil amount is over the red line on the oil level gauge.
6.3.2 CHANGE HYDRAULIC OIL
Remove the plug. Use a container for collecting the used oil. Wrap tape seal around the plug, then
tighten it securely. Fill oil through the oil tank until the oil amount is over the red line of the oil level
gauge.