DoAll C-8056SA, Инструкция по эксплуатации

Страница: 16 / 26

14
(8) Have the back side of the blade come into contact with the saw wheel edge.
(9) Shift the tension lever to position to tighten the blade tension.
(10) Adjust the steel brush position so that it just touches the gullet of blade tooth.
5.2.2 ADJUSTING SAW ARM POSITION
The saw arm position should be properly adjusted according to the workpiece width. Keep the
saw arm as close to the clamping position as possible. Make adjustments according to the
following procedures:
(1) Loosen the lock screw on the guide seats for loosening the tungsten plate. If it is clamped by
the hydraulic system, loosen it from the control panel.
(2) Loosen the fix handle on the left saw arm.
(3) Move the left saw arm to suitable position. A scale is attached on saw guide indicating the
work piece width.
(4) Tighten the fix handle on the left saw arm.
(5) Tighten the lock screw on the guide seats. If it is clamped by the hydraulic.
5.3 OPERATION INSTRUCTIONS:
(1) Select the correct saw blade according to the work piece type.
(2) Install the saw blade.
(3) Properly adjust the saw arm position according to the work piece width.
(4) PLACING THE WORKPIECE
a. Select a suitable speed of saw blade and adjust the position of belt on belt pulley.
b. Open the vise according to the work piece width.
c. Place the work piece on the roller stand.
d. Lower the saw arm until the saw blade is about 15mm above the work piece.
e. Move the work piece into the vise by using the lifting roller or manual. Then, set the
cutting length.
f. Press the "BED VISE CLAMPING SWITCH" to clamp the work piece until the
indication lamp at the right side lights up.
(5) Press the "BLADE START/STOP" switch. At this time the coolant system also starts
running. The coolant will flush out from the right and left tungsten plates and coolant nozzle.
You need to adjust the coolant flow properly.
(6) Adjust the blade speed according to actual cutting condition.
(7) Slowly turn the flow control valve and the pressure valve and check the cutting condition.
NOTE: When the job is finished, remove the work piece and clean the machine.