DoAll C-8056SA, Инструкция по эксплуатации

Страница: 15 / 26

13
7. EMERGENCY STOP SWITCH
When this switch is pressed, the control power is turned off.
8. BLADE START/STOP SWITCH
When the clamping indication lamp for the table lights up, press the upper switch for
starting the saw blade. Press the lower switch for stopping the saw blade.
9. SAW ARM RAISE SWITCH
Press this switch for raising saw arm. When this switch is released, the raising motion
stops.
10. SAW ARM LOWER SWITCH
Press this switch for lowering the saw arm. When this switch is released, the lowering
motion stops.
11. LIFTING ROLLER UPWARD/DOWNWARD SWITCH
Switch to right for roller upward and switch to left for roller downward.
12. SAW BOW STOP POSITION SWITCH
Switch to right: Saw head raises to the highest position and stops after the cutting
finished. Then the saw blade stops.
Switch to left: The saw blade stop without upward moving of saw head after the
cutting finished.
5.2 REPLACING AND ADJUSTING SAWBLADE
5.2.1 REPLACING SAWBLADE
(1) Press the "SAW ARM RAISE" key to raise the saw above the workpiece or the vise.
(2) Open the right and left wheel guards.
(3) Shift the tension lever to position, then the driven wheel will move toward the driving
wheel for loosening the blade tension.
(4) Loosen the screw that tightens the guide seats for loosening the tungsten plate.
(5) Remove the original blade.
CAUTION: Wear gloves for safety when removing the blade.
(6) Place the new blade on the two saw wheels. Twist the blade to place it between the tungsten
plate and auxiliary bearing of the guide seats and let the back of blade touches the upper
tungsten plate. Then, slightly tighten the screw of guide seats.
(7) Shift the tension lever to position to tighten the blade tension. Then return it to the
middle position.