DoAll C-520NC, Инструкция по эксплуатации

Страница: 23 / 33

Segatrici
S.r.l
Instruction Manual
Pag.23
Edition A
(800+2) x 3 = 2406
(500+2) x 3 = 1506
(50+2) x 1 = 52
Total = 5960
The blade thickness (2 mm. in this example) is set in the fix machine parameters, which can be modified only by the manufacturer. Every length the opera-
tor inputs, the NC adds the blade thickness.
To execute this program, the operator should turn the Auto/Manual switch on Auto.
12.1.7. Semi-automatic cycle
The CN015 programmer allows to operate in semi-automatic controlling the length. For example, if the operator has to cut a
bar which was previously cropped without to crop it again, press
↑
→
button and the semi-automatic screen appears showing
the actual position of the index.
Type the desired length, then press E and then START (i.e. 100 “E” - “START”)
To exit the semi-automatic and going back to the edit screen just press BRK
Following there is an example of a semi-automatic cut :
•
Open both the rear and the index vises.
•
Raise the workstop and move the bar against it
•
Insert the semi-automatic cycle and enter the desired length adding the blade thickness (i.e. 100+2) = 102, then press E
and START.
•
The index moves backward ; when it stops, clamp the piece.
•
Raise the blade and make sure the rear vises are open.
•
Type 0 (zero), then E, then START. The index will move forward feeding the material.
•
When the index stops, clamp the material using the rear vises, press the BRK button and the automatic cycle will start.
Please, note that the saw will consider this cut as a crop cut, thus the operator should count a cut less then the number needed
(i.e. : input two if he needs three parts).
S
EMI
-
AUTOMATIC SCREEN
DoALL - SEGATRICI Srl
SEMI AUTOMATIC
=========
0000.0
START
=========
0000.0
=========
0000.0
START
=========
0000.0