DoAll C-520NC, Инструкция по эксплуатации

Страница: 22 / 33

Segatrici
S.r.l
Instruction Manual
Pag.22
Edition A
9. The cursor is now down in the lower area of the edit screen, where the operator has to input lengths and number of cuts. Type the program and
then press E Following there is an example of a complete program ready to run.
DoALL - SEGATRICI
PROG.N. 001 NEXT 001
CYCLE 00004 TOT.00000
BLADE SP. 075 PRES. 010
LENGTH CUTS TOT.
1 00100.0 00005 00000
2 00250.0 00015 00000
3 00050.0 00017 00000
4 01235.5 00008 00000
5 00000.0 00000 00000
6 00000.0 00000 00000
7 00000.0 00000 00000
8 00000.0 00000 00000
9 00000.0 00000 00000
10 00000.0 00000 00000
When all the different lengths have been inserted, go to the following line (in this example line 5) type 0 (zero) and enter it pressing E. All the values be-
low will turn to zero.
10. Press the BRK button, and the cursor will go back to PROG.
11. If the NEXT value is different than the current program number, it is necessary to complete also the program which NEXT makes reference to.
12.1.6 To reduce the waste of material
The cut must be planned so to reduce the amount of material that has to be wasted. The operator has to pay attention to this kind of problem when en-
tering the lengths and the cuts. For example :
LENGTH CUTS TOT.
1 01000.0 “ E ” 00002 “ E ” 00000 “ E ”
2 00800.0 “ E ” 00003 “ E ” 00000 “ E ”
3 00500.0 “ E ” 00003 “ E ” 00000 ” E ”
4 00050.0 “ E ” 00001 “ E ” 00000 “ E ”
5 00000.0 “ E ” Then press BRK
This is an example of a program which use the bar reducing the quantity of waste. In fact, if the bar is 6 meters long :
(1000+2) x 2 = 2004