DNIPRO M JS-110SF, Руководство пользователя

Страница: 27 / 48

ENG
JS-110SF
23
Switching On/Off (Fig. 4)
Switching the jig saw On/Off is performed with the switch button (Fig. 4)
The design of the switch (1) implies the possibility of fixing it in «On» position with
the lock button (2).
Never leave the electric tool with a locked switch button.
Cutting angle adjustment (Fig. 5)
Before to start cutting angle adjustment, it is recommended to disconnect mains
cable from the socket.
With a jig saw you can bevel the material at an angle up to 45
о
. To adjust the cutting angle,
you shall:
1. Release support foot fastening bolts with hex wrench from set of supply.
2. Slightly move a support foot back and turn it with the scale to the required bevelled cut
(up to 45
о
).
3. Move support foot forward and tighten loose screws.
Use of pendulum run (fig. 6)
Pendulum run system has four modes of operation. With the lever (mode switch), you
can adjust the pendulum run.
To change the mode, move the mode switch to one of the following positions:
START
STOP
Fig. 4
Fig. 5