Page
|
15
Marquee
Technical
Guide
‐
Version
6.2.0
–
090110
11Giraffes
©2010
All
Rights
Reserved
Installing Video Pass-Thru (High Definition)
Using The Hauppauge HD-
PVR
•
Run the necessary cable (Component, S-Video or Composite video and RCA-Type Stereo
Audio) from the video source to the media player. Note that HD video requires component
video to be utilized.
•
Verify the source video using this cabling.
•
Power down the digital media player.
•
Place the HD-PVR in close proximity to the Marquee media player.
•
Determine if the source video is high or standard definition.
You have several options for
connecting the source video, HD-PVR and Marquee media player. If you desire to utilize
source High Definition video, follow these instructions and refer to Figure 1, below. If you
desire to utilize source Standard Definition video, skip to step 6.
a.
Connect the source video to the rear panel Component Video In using the included
cable.
b.
Connect the source audio to the rear panel red & white RCA-type Audio In connectors
on the bottom-left. Note: When using component video, you must utilize the audio
connectors on the rear of the HD-PVR. The optical audio in is not supported.
c.
Connect the included USB cable to the connector labeled USB on the rear of the HD-
PVR. Connect the other end of the USB cable to any rear-panel USB port on the back of
the Marquee player.
If you desire to utilize Standard Definition video, you may use the included component video
cable as described in step (above), or you may do one of the following (refer to Figure 2,
below).
a.
Connect the source video to the front panel S-Video In or Composite Video In. Note
that these cables are not provided.
b.
Connect the source audio to the front panel red & white RCA-type Audio In connectors.
Note: When using S-Video or
c.
Composite, you must utilize the audio connectors on the front of the HD-PVR.
d.
Connect the included USB cable to the connector labeled USB on the rear of the HD-
PVR. Connect the other end of the USB cable to any rear-panel USB port on the back of
the Marquee player.
•
Turn power onto the video source.
•
Turn power onto the displays.
•
Turn power onto the Marquee media player.
