Page
|
7
Marquee
Technical
Guide
‐
Version
6.2.0
–
090110
11Giraffes
©2010
All
Rights
Reserved
portrait mode, and if live TV or other external video is to be presented on the screens. For
more detailed information on these and other scenarios, consult the current Marquee
Installation Instructions.
3. Out of the box, the W610 defaults to operate from a wired network connection. If
performing a wireless setup, you will need to know the following information in advance of
performing configuration:
–
SSID
–
Encryption Key Type (e.g., WEP/WPA)
–
Passphrase type (ASCII/Hex). If this is unknown, and the key contains
only the letters A-F and numbers, it is most likely a Hex key.
–
Passphrase or Key
After obtaining this information, please follow the instructions later in this document under
Wireless Installations.
4. The default network configuration uses DHCP to acquire a network address. If a static IP
address if preferred or required, follow the instructions later in this document.
step
by step instructions
Identify a discreet location for placement of the media player. Ideally, it should have limited
access and be near an existing network port to the Internet. A network/phone closet, manager’s
office or other secure location is recommended. Place the media player in a location near the
dedicated power source, the available network port, and where at least 3” of airflow is
available around the unit. The media player may be mounted on its side if necessary.
Confirm availability of a dedicated (non-switched) power source. The media player receives
content and software updates overnight. It should not be powered by a source that is turned off
at any time.
Note that standard broadband Internet access is required. In addition, HTTP, HTTPS and SFTP
ports (80, 443 and 22, respectively) should be enabled.
Recommended Step – Verify Internet Access: Using a laptop (or other network device), connect
to the existing network and confirm that www.Marquee11.com
can be pinged. If it is not
accessible, network connectivity must be corrected prior to proceeding.
Wired
- Connect one end of the included Ethernet patch cable to the existing host network port.
Connect the other end of the Ethernet patch cable to the RJ-45 Ethernet port on the rear of the
media player.
Wireless
- Connect the wireless antenna to the antenna
post on the rear of the media player.
