Page
|
6
Marquee
Technical
Guide
‐
Version
6.2.0
–
090110
11Giraffes
©2010
All
Rights
Reserved
installation
of W610 player
required
tools & equipment
•
Ethernet patch cable (for wired configuration)
•
HDMI, VGA (DDC2 Recommended) or DVI display cable(s)
•
Male 1/8” (3.5mm) cable (for non-HDMI audio)
helpful
tools for player configuration and troubleshooting
•
Laptop computer
•
USB keyboard
•
Network cable tester
•
label maker (to label any cables that may run a long distance)
•
Spare RJ-45 (Ethernet) connectors
•
Tie wraps
•
Cable cutter
DMX
support hours
•
M-F 7:30 AM to 7:30 PM, CST
•
Saturday 9:00 AM to 6:00 PM, CST
pre installation steps
1.
Standard wired or wireless broadband Internet access is required. In addition, HTTP,
HTTPS and SFTP ports (80, 443 and 22, respectively) should be enabled. Specific IP ranges to
configure firewall settings are listed in the Optimal Firewall Configuration section of this
document.
2.
Verify displays support Marquee. Most displays on the market today will support Marquee.
If the client has an existing video distribution solution, the below recommendations will help
ensure the monitors take maximum advantage of Marquee:
a.
Identify inputs (e.g., HDMI, VGA, DVI) that can / will be used.
b.
Determine the location where Marquee player(s) will be installed. Ensure that dedicated
(non-switched) power is present, and that network cabling or wireless coverage is
available.
c.
Review the video distribution requirements for distances and numbers of screens.
The distance from the signage player to each monitor, and functionality required, dictates
the type of connection. Distances of less than 100 feet may not need any amplification of
signal and may be able to split signal to up to three monitors using VGA two way splitters and
high quality VGA cables. Review supporting documentation for any solution over three
monitors and or a distance of over 100 feet. Please verify if content is being presented in
landscape or
