8
714N-POE Installation and Programming Guide | Digital Monitoring Products, Inc.
PROGRAM THE 714N-POE MODULE
When you program the 714N-POE module, you must use a keypad connected to the programming
header and set to address 1.
You can also program the module from an XR150/XR550 Series panel. Initial programming of
device and communication must be performed with a keypad. Afterwards, device programming
and 714N-POE options may be programmed from the panel’s programming interface. The panel’s
programming overrides any programming performed from a keypad connected to the module.
RESET HEADER
To reset the module when first installing the system, short the two pins on the reset header before
applying power to the module.
To reset the module while the system is operational, short the two pins on the reset header for one or
two seconds without powering down the system.
