DMC UniDriv, Руководство пользователя

Страница: 52 / 86

52
Installation and Operation UniDriv
Section 15 Operating Instructions
1. Unit may be started with all the augers engaged with ONE RING OF GRAIN IN THE
BIN.
2. Always start the unit when one ring of grain is in the bin and ALLOW IT TO RUN DUR-
ING REMAINING FILLING AND EMPTYING OPERATIONS.
3. Check to be sure all belts are in place and idlers are engaged.
A. To engage augers, move idler handle to right.
B. To disengage augers, move idler handle to left.
4. Start the unit.
NEVER HANDLE BELTS UNLESS POWER IS OFF.
NEVER OVERFILL THE BIN: The top of the grain hill at any given auger should be 3” below
the bottom bearing. If the grain level is at or below the bottom of the top ring but the grain level
on the center auger is too close to the bottom bearing, you can place a Leveling Disc, 106B114,
on that auger. The Leveling Disc should not have to run in deep corn, it could ruin the bearings on
that auger. Also, we do not suggest having to use more than one on a unit.
Section 14 Stirall UniDriv Precautionary Check List (continued)
6. All obstructions must be removed from the bin so the horizontal beam and auger can
rotate freely.
7. Check alignment and tension of all belts and pulleys.
8. Check all nuts and bolts, including those on factory assemblies, to be sure they are
tight.
9. NOTE: When the unit is not in use for extended periods of time, disengage idlers to
relax belt tension and increase belt life.
NEVER HANDLE BELTS UNLESS POWER IS OFF.
!!Caution!! DO NOT OPERATE UniDriv in an empty bin.
To test if powered, make sure no one is inside bin, then
turn power “ON” and “OFF” IMMEDIATELY from OUT-
SIDE of the bin. Do NOT let it run in an empty bin. Take
time for proper installation.