DMC UniDriv, Руководство пользователя

Страница: 14 / 86

14
Center Hanger UniDriv
Figure 3-1 Center Hanger to Bracket Detail
Section 3 Center Hanger
For the following steps refer to Figures 3-1 and 3-2.
1. Slide the adjustable hanger bracket (252050) on
the main beam until the edge of the bracket is 1
5/8” from the end of the beam. Secure in place
with the 1/2” x 1 1/2” bolt.
2. Place a clip angle on the 3/4” x 3” bolt (S-8981)
with the leg facing away from the bolt head.
3. Place a spacer on the 3/4” bolt.
4. Put the end of the hanger bar between the arms
of the hanger bracket so the hold is below the
arms.
5. Insert the 3/4” x 3” bolt through the hole in the
hanger bar until the head of the bolt holds the clip
angle over the arm of the bracket.
6. Place the second spacer on the 3/4” bolt.
7. Place the second clip angle over the 3/4” x 3” bolt
so the leg points toward the head of the bolt and
extends over the second hanger bracket arm.
8. Now position the center hanger midway on the
hanger bracket bars and tighten down the 3/4”
lock washer and nut. Final adjustment will be
made when filling the bin.
9. Place one piece of 1/4” proof coil chain through
one hole in the hanger bracket and secure the
end of the chain back to the chain body with the
Quick-Link chain connector provided.
10. Repeat the above step on the opposite side of the
hanger-bracket.
NOTE: The coupling on the rotary connector and the
nipple on the center hanger assembly are left hand
threaded.
11. Install the rotary connector onto the center hanger
and tighten.
12. Place the spreader bar between the two 1/4” proof
coil chains so there are an equal number of links
on each side between the hanger bracket and the
spreader bar. Approximately 32” between the hanger
bracket and the spreader bar is appropriate for most
bins. Secure the spreader bar by bolting one chain
to each end of the bar with the 3/8” x 2” bolts
(S-7687) and nuts (S-456) and the 3/8” flat washers
(S-248) provided.
NOTE:In some small bin diameters the spreader bar pro-
vided may be too long. If this is the case, the
desired length can be obtained by cutting off the
spreader bar and re-drilling.
13. Fasten the “S” hook on the rotary stabilizer to the
hanger chain just above the center hanger bracket
and squeeze the “S” hook closed.
1 5/8”
S-234
S-233
S-8981