DMC UniDriv, Руководство пользователя

Страница: 11 / 86

11
Track Installation UniDriv
Section 1 Track Installation
1. Refer to Figure 1-1. Pre-assemble the lug (256004) using the 3/8” x 1-1/4” Bolt (S-7767),
3/8” Hex Nut (S-7525), and 3/8” Lock Washer (S-1054) loosely to the Track Bracket .
Install the track bracket assemblies using the 5/16” x 1-1/2” Bin Bolt (S-277), 18-3/4” apart
around the inside bin wall eaves. Most bins have existing holes on 9-3/8” centers. If this is
the case install the track brackets using every other hole. If the hole in the bin wall panel
lies in the valley use an extra nut and washer as necessary to mount the bracket flush. The
bracket can now be used as a template for the bottom hole. Use the hole that best suits
the corrugation.
NOTE: The bracket must be bolted top and bottom.
2. Place a section of track into each track bracket so its bottom edge rests on the 3/8” x 1-1/
4” bolt between the lug and bracket.
3. Tighten the bolts to clamp the track in place.
4. Place a second section of track into the adjacent brackets so the end of the second
section of track butts against the end of the first section of track. See Figure 1-2. Note:
The track must be installed in the brackets so that the splice bolt holes are closest to the
bottom edge.
5. Using the 5/16” x 1” bolts (2FH5733) install a Track Splice (255002) behind and flush with
the bottom of the track. Tighten the splice so that the track section on the right is slightly
lower then the one on the left.
6. Cut the last track section to fit and drill the splice holes using the cut off piece as a
template.
NOTE: Caution must be taken to not leave a gap at the splice as it may cause the drive
wheels to slip.
PRIOR TO ASSEMBLY AND INSTALLATION
CONSULT THE BIN ERECTION MANUAL OR
MANUFACTURER FOR ANY SPECIAL UNIT
HANGING OR SUPPORT LOCATIONS.