DMC Hi Cap 54, Руководство пользователя

Страница: 24 / 61

Photo 53
Photo 52
Photo 51
Step 52. Bolt 10” auger winch to rear
frame, using two 3/8” x 1” hex
bolts, lock washers and hex nuts.
Unwind small portion of cable and
place over lift assembly pulley.
Remove clevis pin and place
cable loop over clevis pin.
Re-install. See Photo 51.
Step 53. Bolt discharge spout to rear
frame, using two 1/4” x 5/8” hex
flange screws and hex flange lock
nuts. Third spout bolt is used in
conjunction with drum shield
braces. See Photo 51.
Step 54. Install two rear drum shield braces. Braces should be positioned with long leg
down. Bolt upper end of braces to shield bracket using two 5/16” x 3/4” hex
bolts, lock washers and hex nuts. Secure slotted end of brace brackets with
two 5/16” x 3/4” carriage bolts, 1/4” flat washers, lock washers and hex nuts. Tilt
top of drum shield in or out for proper alignment. Then, tighten the bolts. See
Photo 51.
Step 55. Install 24’ cone drive pulley on to drum
axle with hub of pulley to the outside.
Align pulley with spring loaded idler
and small “V” drive pulley. BE SURE
3/8” x 1-3/4” square key is in position.
After alignment, tighten set screws
firmly. Next, install BB-120 double “V”
belt on to cone drive pulleys. See
Photo 52.
Step 56. Install rear cone drive belt shield,
using six 1/2” flat washers and six
hex nuts. BE SURE THERE IS A
FLAT WASHER ON EACH SIDE OF
CONE DRIVE BELT SHIELD. Adjust
shield so it is as close to the pulleys
as possible. Do not allow shield to
drag on the pulleys. See Photo 53.
15