DMC Hi Cap 54, Руководство пользователя

Страница: 13 / 61

Step 11. Trash pan assembly consists
of a left and right side panel
and two ends. Start by
positioning side panel as
shown in Photo 12.
NOTE: STRAIGHT END OF
PANEL TOWARD FRONT.
Secure to cleaner side
channel. Secure to trash pan
bottom with 1/4” x 5/8” hex
flange screws and hex flange
lock nuts. DO NOT TIGHTEN
BOLTS OR PUT BOLTS IN
FIRST AND LAST HOLE.
Step 12. Bolt front end of trash pan
into position by placing end
panel lip under side panel,
using fourteen 1/4” x 5/8” hex
flange screws and hex flange
lock nuts. See Photo 13.
DO NOT TIGHTEN BOLTS
Step 13. Continue by bolting other half
of trash pan on to side rail and
trash pan bottom. Be sure side
panel lays on top of front panel
lip. Use seven 1/4” x 3/4” hex
bolts, flat washers, lock washers
and hex nuts, and ten 1/4” x 5/8”
hex flange screws and hex flange
lock nuts. OMIT BOTTOM BOLT
AT THE REAR. Do not tighten
bolts at this time.
Step 14. Install 10” trash pan auger
(ribbon flighting) with key-way
end of shaft installed into front
trash pan bearing. See Photo 14.
Step 15. Bolt rear panel of trash pan into
position, using twelve 1/4” x 5/8”
hex flange screws, hex flange
lock nuts. TIGHTEN ALL TRASH
PAN BOLTS AT THIS TIME.
Photo 12
Photo 13
Photo 14
4