DMC Hi Cap 54, Руководство пользователя

Страница: 18 / 61

Step 32. Bolt V-belt idler pulley to rear frame position, using one 1/2” x 4-1/2” full-thread
hex bolt, two 1/2” flat washers, one 1/2” x 3/4” spacer bushing and lock
washers, and hex nuts. See Photo 30.
Step 33. Bolt on rear belt shield bracket, using two 5/16” x 3/4” hex bolts, lock washers
and hex nuts. Next, place 3/8” SAE washer and compression spring on rod
attached to idler arm. Put rod through shield bracket hole. Fasten the pulley
and idler bracket to the grain cleaner, using one 3/8” x 3” hex head bolt, and
3/8” lock nut. DO NOT OVERTIGHTEN. THE ARM AND PULLEY ASSEMBLY
MUST SWING FREELY. See Photo 31.
The main component parts of the drum are shown in their respective position in Photo 32.
Step 34. Bolt the large, six-spoke cone ring to the disc on the shortest end of drum
axle, using three 3/8” x 1” hex bolts, lock washers and hex nuts.
See Photo 33.
DRUM SET-UP PROCEDURE
Photo 30
Photo 31
Photo 32
Photo 33
9