DMC Hi Cap 54, Руководство пользователя

Страница: 23 / 61

Step 47. Lift drum on to cleaner transport. As drum is being lowered toward the trans-
port, BE SURE TO HOOK DRUM DRIVE BELTS OVER DRUM BEARING
ANGLE SUPPORT. See Photos 48 and 49.
Step 48. Bolt front drum support angle bracket to front frame, using two 3/8” x 3-1/2”
hex head bolts, lock washers and hex nuts. The bearing should be mounted
under the bracket. See Photo 49.
Photo 48
Photo 49
Photo 50
Step 49. Bolt rear drum bearing to rear
frame, using two 3/8” x 1” hex head
bolts, lock washers and hex nuts. After
wood bearing is secured, pull drum
toward rear until front roll pin is against
front bearing. Finish by locking rear
shaft collar against wood bearing.
See Photo 50.
Step 50. Using two 5/16” x 3/4” hex bolts, lock washers and hex nuts, bolt drum
discharge shield to rear frame, as shown in Photo 51.
Step 51. Bolt 10” auger lift assembly on to rear frame, using one 3/8” x 3-1/2” hex head
bolt and hex lock nut. NOTE: DO NOT OVERTIGHTEN NUT AS THE LIFT
ASSEMBLY MUST PIVOT FREELY. See Photo 51.
14