DKS Series 6050, Инструкция по установке и эксплуатации

Страница: 29 / 42

6050-065-D-2-16 2 5
4502-010
KEY SWITCH
DATA
9
10
11
12
13
14
15
ON 12345678
ON 12345678
NC
NO
SW 4
SW 3
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
Monitored CLOSE
Photo Sensor
Monitored OPEN Photo Sensor...OR...
Potential
Entrapment
Area
DoorKing Access Control System (Model 1833, 1835, 1837 or
1838) tracker system can be connected.
This system can keep track of gate operator cycle count, shorted
inputs, loop detector problems, any forced entry attempts, if the
gate has struck anything during the open or close cycle, power
interruptions, etc.
For more detailed information
refer to the Tracker Board
Installation and Wiring
Manual, DoorKing P/N
2358-010.
Terminal 11 required only
if the tracker board will
activate the gate
operator. Refer to the
manual 2358-065 for
detailed information.
3 1 2 4 5 6 7 8 10 9
Gate Tracker
(Quad Box Shown)
DATA
Alarm Output Alarm Reset Input Common Tracker Data Tracker Data Tracker Data Monitored CLOSE Beam Common Monitored OPEN/CLOSE Edge/Beam Common
Optional External Alarm Reset Button Connection
24 VAC Power
12 VAC Power
Auxiliary
Terminal
..........Monitored OPEN/CLOSE Reversing Edge
OPTIONAL Wireless Note: Refer to the instruction
sheet that comes with the receiver/transmitter for
more specific wiring and mounting instructions.
Mointored Sensor Note:
Only 1 monitored Device
can be connected to
each input.
12 or 24 VAC
Wireless Receiver
for Reversing Edge
250 ma
max
24 VAC
OR
12 VAC
Power
Normally Closed (N.C.)
Normally Closed (N.C.)
Com
To Com
To Reversing
Edge
OPEN Beam
OPEN/CLOSE
Edge
CLOSE Beam
4.3 Auxiliary Terminal Wiring
External Entrapment Protection Devices:
In addition to the inherent reversing sensor system,
this operator has a 10-pin Aux terminal for the
connection of photo sensors-Type B1 and/or
reversing edge-Type B2 entrapment protection
required for UL 325 standards.
An external entrapment protection device MUST be
installed or the operator will NOT function.
Only 1 monitored Device can be connected to each
input. An
OPTIONAL Expansion Kit (sold separately)
will allow connection for additional devices.
IMPORTANT: Photo sensors must use Normally Closed (NC)
contacts with the beam set for light operate (relay activated
when beam is not obstructed).
SW 3, Switch 8
MUST be ON
for aux terminal
9 & 10.
SW 3, Switch 7
MUST be ON
for aux terminal
7 & 8.
ON 123456
7
8
SW 3
ON
1234567
8
SW 3
Potential
Entrapment
Area