DKL CHAIRS L2-ECO, Руководство по эксплуатации

Страница: 201 / 266

7117100018L30 1712V002
11
Product description
As soon as no further fluid is fed to the amal-
gam separator, e�g� when the suction hose is
placed back in the hose manifold, the centrifuge
drum is switched off after a short delay time�
This switch-off brakes the motor, as a result
of which the ring of water, which continues to
rotate due to inertia, rinses the separated parti-
cles out of the centrifuge (8) downwards into the
collector vessel�
The separated amalgam particles form a sed-
iment in the replaceable collector vessel� The
level of fluid in the collector is regulated by the
pump cone so that the risk of fluid escaping
when the collector vessel is changed can be
avoided�
5.6 Sediment level measurement
The fill level in the collector vessel (12) is
checked by a float sensor (13) every time the
main power switch is switched on�
The centrifuge motor starts, fluid is transported
via the pump cone to the centrifuge drum (8)
and provides a constant level of fluid (under-
side of the cone pump) in the collector vessel�
The float sensor sinks� Two light barriers (9a)
and (9b) measure the fluid level� Once the level
reaches 95% in the collector vessel, this is dis-
played on the display panel�
5.7 Operating problems
If the unit is not ready for operation due to a
fault, this will be indicated on the display panel
via illuminated LEDs and an audible signal�
5.8 Service key
On the display panel there is a service key that
can be used to switch off the audible signal in
the event of a fill level warning or if a fault mes-
sage is indicated� This button can also be used
to start the device manually� To do this, press
the button for longer than 2 seconds until the
drive motor starts up�
EN