DK-1100A Ink Roll Coder
Operation Manual
3.1.3 Installing and Mounting the DK-1100A Print Head
Install the mounting bracket assembly to the packing machine where
will be easy to operate the printer. Make sure there will be room in
front of the print head for the operator to change the ink roll and type
holder. The packaging film can round through the pressure roller and
make less than 120
wrap (as diagram 5).
3.1.4 Installing the Control Box
Printer
Printer
Packaging Film
Packaging Film
Roller
Roller
120
120
Diagram 5
IMPORTANT: Mount the control box away from potential sources of water spray or cleaning
solutions. The control box connectors are not sealed from harsh
environments.
Install the print head cable to the print head, as below diagram.
I/O cable
This cable has 3-pin plug-in, can input print signal. Match the proximity sensor to
the correct color wires. Refer to Diagram 6.
Drive cable:
This cable has 7-pin plug-in, connecting the print head and the control box.
Power cable:
This cable has plug-in and three wires, connecting the control box and power
supply. The cable can get the power supply from packaging machine.
IMPORTANT: Never connect or disconnect the cables to the DK-1100A control box with the
power on. Failure to do this may result in personal injury.
NOTE
Requires AC220V 50/60Hz power, well ground connection.
I/O
Cable
Data
Cable
1
0
I / O
Drive Connect
Power Supply
AC 220V
Power Cable
Diagram 6
SHANGHAI DIKAI SEPARATE MACHINERY CO., LTD.
SHANGHAI DIKAI SEPARATE MACHINERY CO., LTD.
3-13
3-13
