dji XP3.1, Руководство пользователя

Страница: 27 / 48

27
Figure 3. 34
Attention:
If JR remote controller is adopted, the TRVL ADJ setting value should be
about 80%, While in Futaba being 60% more or less. Moreover, if FUTABA
remote controller is adopted, slide movement can be noticed by reducing
fewer than 80%.
4）
When switch is upside, the slide leveling with the red line, the green LED
should vanish constantly, and then it is the manual mode. When switch is
downside, the slide leveling with the green line, the green LED indicator
should begin to sparkle, which shows having entered into auto mode. If
users can get all above, you have finished the adjustment. Please click
“next” to continue the next step.
Note
：
○
1
：
It should be TRVL ADJ in JR RC or END POINT in Futaba RC.
○
2
：
This step has set a third mode beyond autopilot and manual mode. Helicopter will enter fail safe mode
if the RC receiver loses signals. Control system will enter fail safe once autopilot/manual switch
enter any position beyond the two fixed ones set in step3. So any position (Figure 3. 34) is acceptable
if users do not set fail safe as the approach position of autopilot or manual.
STEP3. 【Swash Type Setting】：
Under the manual mode, users can adjust the helicopter according to
the requirements for ordinary remote-controller helicopter.
1) Before this step, set the swash type as NORMAL mode remote controller first。
2) If your helicopter is Not CCPM mode, set the Swash types as NORMAL in the
software (Figure 3. 35). click “write ”and then “next” to enter the
interface of “Feedback & Servo Calibration”。
Swash Type:
Swash Type Ccpm Parameter
Normal Type Normal －
Swash Mix
Ccpm Type
1. 3_Servo_120°
2. 3_Servo_140°
3. 3_Servo_90°
4. 4_Servo_90°
NORM 、REV（Servo Rotation Direction）