DirecTV HIRD-B2, Руководство пользователя

Страница: 36 / 92

HUGHES-BRAND DIRECTV SYSTEM OWNER’S MANUAL
P
AGE
4-12
2) Dig a hole at least 8-inches in diameter and 36-inches deep. If you live in an area where the
frost line goes deeper than 30-inches, dig the hole at least 6-
inches deeper than the frost line.
3) Place the pole into the hole and place rocks (for example)
around the pole to stabilize it in a vertical position.
4) Using a carpenter’s level, plumb the pole in at least two different locations on the side of the
pole, as shown. These two measurements should be at right
angles to each other. When the pole is plumb, secure it with the
rocks, or attach guy wires to hold it upright.
5) Fill the hole with prepared quick drying cement. Shape the top
of the concrete with a slope to improve drainage.
6) Let the cement dry for 24 hours before you remove the guy
wires or attempt to attach the antenna to the pole.
With the pole installed, proceed to the section titled “Attaching the
Reflector Onto the LNB Support Arm” later in this chapter.
Attaching the Reflector onto the
LNB Support Arm
There are two possible antenna models that may have been included with your DIRECTV System.
Refer to the section that applies to your antenna model. If you don’t know which model number
you have, you should be able to identify it by the associated diagram.