5
933.SUBARU1 1.38.195.3 2010 Subaru Forester
©2022 VOXX•DEI LLC. All rights reserved.
Pre-installation and application warnings
START
HERE
This section highlights important information for this specific firmware and will assist in pricing accordingly, as
well as bringing awareness to any operational or vehicle limitations.
Compatibilities and Requirements
T-Harness
compatible
T-Harness is not compatible.
Keys required for
programming
1
Keys required
for operation
0
Vehicle Takeover
Refer to the
Quick Reference Guide
section for more details.
Firmware notes
Brake Status types:
Depending on the origin of the vehicle, it could have one of two Brake Status types with the default setting as
Type 1. If the brake does not shut the vehicle down under a remote start condition, program the Brake Status as Type 2. This can be
done when flashing the module found under Data Feature Configuration when flashing the firmware.
Key2GO:
Mandatory to control the immobilizer override in this firmware.
Fuse Positioning:
It is important to check that the fuses are positioned correctly in the module. Proper fuse positioning is displayed on
each wiring diagram.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.
Refer to the "Vehicle connections" following the installation diagram.
Footnotes
[1] Hood pin:
The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin, or if
not supported in data.
[2] Siren:
The siren is only required when enabling the security features during module flashing.
[3] Green wire:
only required for starter disable and antigrind applications.
[4] Keysense Input:
Connection is only needed if keysense is not recognized through data at the time of programming. See LED
Diagnostics & Troubleshooting section for more details.
[5] Diode:
When using an external relay, use a 1N4002 diode or larger.
