15
933.SUBARU1 1.38.195.3 2010 Subaru Forester
©2022 VOXX•DEI LLC. All rights reserved.
Pairing Remotes
To enter pairing:
1
Open
the driver side door.
2
Turn
the vehicle ignition to the ON position.
OR
Press
the PTS button to turn the ignition ON.
* The number of times the PTS button is pressed depends on the vehicle.
START
Key OUT
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
START
Key IN
ON
OFF
OR
3
Within 10 seconds,
press
and
release
once, and then
press
and
hold
the programming button on the Control Center (antenna) or the LED/Valet Pod
(standalone switch) until the LED starts flashing then
release
the button.
* Your antenna may differ from the model shown in the illustration.
Press &
Release
&
&
&
OR
* *
Note
: Connected devices become registered within 4 to 6 seconds.
8556T Temperature Sensor
The 8556T Temperature Sensor is optional, but included with your DS3+/DS4+ module.
When used, the Temperature Sensor must be plugged into the 2-pin black connector of your module.
Note
: When the system is configured as a remote starter, the temperature is reported by the 8556T Temperature
Sensor. When security features are enabled, it is reported by the 8504D Combo Sensor.
8504D Combo Sensor
The 8504D Combo Sensor is optional, but included with the purchase of a DS4SU security package.
The Combo Sensor is preset for the majority of applications; however, it can be adjusted using the DirectLink
application, as well as a compatible LED or LCD remote. Please refer to the instructions included with the DS4SU for
more information on how to make adjustments.
Note
: When the system is configured as a remote starter, the temperature is reported by the 8556T Temperature Sensor.
When security features are enabled, it is reported by the 8504D Combo Sensor.
IMPORTANT:
The Combo Sensor must be paired to the device before it can be used.
RF Systems
An RF System consists of one or multiple remotes, a Control Center (antenna), and an antenna cable – various combinations exist. An RF
System allows the vehicle owner to control the system with enhanced range. Two-way models are available. Please follow the instructions
included with the kit for appropriate installation and programming information.
..
When used in conjunction with Directed SmartStart
®
To enable D2D communication between the DS3+/DS4+ and the Directed SmartStart
®
one of the following actions must be performed
before providing power to the Directed SmartStart
®
unit:
SmartStart with
Loops
– The brown loop must be cut.
SmartStart with
Pigtails
– The gray wire must be connected to a ground source.
Loops
Pigtails
DO NOT
connect the Directed SmartStart
®
2-pin power harness when using the DS3+/DS4+. Power and ground will be provided by the
D2D connector on the module. Refer to the Directed SmartStart
®
documentation for further details.
