11
933.SUBARU1 1.38.195.3 2010 Subaru Forester
©2022 VOXX•DEI LLC. All rights reserved.
Module programming
For
Security-only
and
Convenience-only (skip transponder)
programming, see next sections.
1
Ensure vehicle is in a safe location, and cannot move forward during programming. For
vehicles equipped with a manual transmission, make sure the gearshift lever is in the neutral
position.
2
DS3+: Connect the 12-pin main power harness to the DS3+ module FIRST.
Wait until the LED turns ON solid red before proceeding to the next step.
DS4+: Connect the 12-pin main power harness to the DS4+ module FIRST.
The LED will turn ON solid Blue for 1 second to confirm Bluetooth communication.
Wait until the LED turns ON solid red before proceeding to the next step.
3
Connect the remaining harnesses to the DS4+ module.
4
Insert and turn the key to the ON position.
The LED will flash orange, then green.
5
Start the vehicle by turning the key.
The LED will flash orange slowly.
1.
Turn the vehicle OFF.
2.
6
Remove the module from the vehicle and reconnect it to your computer.
The website will automatically recognize that you are moving onto the second phase of the
programming sequence.
7
Click
Submit Key2GO Request
.
8
When the configuration is completed, reconnect the module.
The LED will turn ON solid green for 3 seconds, then turn OFF.
9
When the module is successfully programmed,remove the key from the ignition barrel.
10
Pair remotes (if applicable).
For information on how to pair a specific remote, please refer to its corresponding owner
documentation, which can be found inside the product packaging of the complete system or
on www.directechs.com.*
11
DATA/Hardwired Tach Learning: When using Data Tach, it is recommended to follow the Tach
Learning procedure. However, when using a Hardwired Tach, the procedure is mandatory.
For more information, refer to the Tach Learning procedure section.
* Your aftermarket remote may differ from the model shown in the illustrations.
