LUBRICATION
30
WARNING: Never lubricate or clean any part while
the machine and/or tractor engine is running.
IMPORTANT! Frequent lubrication and greasing in
correct quantity will reduce the wear on components
and could reduce the frequency of breakdowns.
DRIVELINE
To prevent the telescopic shaft on the driveline from
blocking, assemble both sections and grease the tubular
shaft with about two ounces of grease (Figure 40).
Lubricate the driveline at the greasing points shown in
Figure 41. Slide the cone in order to access the grease
fittings. Refer to page 43 for the complete instruc
-
tions on how to assemble and disassemble the driveline
guard cones.
Figure 40 Lubrication points
Figure 41 Lubrication points
SPEED REDUCER
The speed reducer of the Forage Blower should be ver-
ified after ten hours of operation and then at the begin
-
ning of the season and afterwards, every 100 hours of
operation.
It is recommended to use 80W90 (S5524952P /1 litre)
oil in the speed reducer. Check to make sure that there
are no oil leakages around the joints of the speed re-
ducer. Oil should be changed if its color has changed
or if there is foam indicating traces of water. Otherwise,
change oil once a year.
LUBRICATION CHART
These symbols indicate specific points which should be greased, oiled and verified
.
Manual no. S5516E970
E
V1.1
