ASSEMBLY INSTRUCTIONS
21
HYDRAULIC WHEEL INSTALLATION IN-
STRUCTIONS
Follow this procedure to install the hydraulic wheels lift
system.
1. Remove the two existing Blower wheels.
Figure 17
2. On each side of the Blower, remove the pivot axle
(item 1) and the up-down handle (item 2).
1
2
Figure 18
3. Cut and remove the up-down handle support bracket
(item 3), on each side of the Blower. Replace the two
1/2” nuts (item 4) with two retaining washers (item
6). These washers will make the installation of the
support much easier. Keep the two nuts (item 4) as
well the bolt (item 5). They will be needed to install
the support (item 6 of Figure 21).
3
4
6
5
Figure 19
4. If necessary, grind the two sections indicated in
Figure 20. This will allow the support (item 7 of Fig-
ure 21) to rest evenly on the frame.
Grind this area
if necessary
Grind this area
if necessary
Figure 20
Manual no. S5516E970
E
V1.1
