DINGLI JCPT DCS Series, Руководство по обучению

Страница: 34 / 87

培训手册
Training Manual
操作前检查
Pre-operation Inspection
JCPT- DCS
www.cndingli.com
3-8
⊙ 结果：机器应按照控制面板上向下箭头所指示的方向移动，然后突然停止。（
Result: The
machine should move in the direction that the yellow down arrow points on the control panel,
then come to an abrupt stop.
）
注意：刹车必须能够使机器在能够攀爬的任何坡度上停稳。
Note: The brakes must be able to hold the machine on any slope it is able to climb.
测试限制的驱动速度（
Test Limited Drive Speed
）
35)
按下起升功能选择按钮，指示灯亮。按住控制手柄上的功能启用按钮，升起平台到距离地面约
2m
高度。（
Press and hold the lift function enable switch. Raise the platform approximately
2m from the ground.
）
⊙ 结果：坑洞保护装置展开。（
Result: The pothole guards should deploy.
）
36)
按下驱动功能选择按钮，指示灯亮。（
Press and hold the function enable switch on the
control handle.
）
37)
按住控制手柄上的功能启用按钮，缓慢移动控制手柄至完全驱动位置。（
Slowly move the
control handle to the full drive position.
）
⊙ 结果：平台升起状态下最大驱动速度不应超过
20cm/s
。（
Result: The maximum achievable
drive speed with the platform raised should not exceed 20cm/s.
）
¤ 结果：平台升起状态下最大驱动速度超过
20cm/s
，请立即标记机器。并停止运行。（
Result: If
the drive speed with the platform raised exceeds 20cm/s, immediately tag and remove the
machine from service.
）
测试倾斜传感器操作（
Test the Tilt Sensor Operation
）
注意：在地面上用平台控制器进行该项测试。不要站在平台里面。
Note: Perform this test from the ground with the platform controller. Do not stand in the platform.
38)
完全降下平台。（
Fully lower the platform.
）
39)
将一侧的两个轮驱动到一个
3.5×20cm
的垫块上。（
Place a 3.5×20cm or similar piece of
wood under both wheels on one side and drive the machine up onto them.
）
40)
将平台起升至少
2m
。（
Raise the platform at least 2m.
）
⊙ 结果：平台应停止运动，同时倾斜警报应每分钟鸣响
150
次。（
Result: The platform should
stop and the tilt alarm will sound at 180 beeps per minute.
）
41)
按照向上箭头指示的方向移动驱动控制手柄，然后再按照向下箭头指示的方向移动。（
Move
the drive control handle in the direction indicated by the blue up arrow, then move the drive
control handle in the direction indicated by the white down arrow.
）
⊙ 结果：驱动功能在任一方向上都不应工作。（
Result: The drive function should not work in
either direction.
）