DINGLI JCPT DCS Series, Руководство по обучению

Страница: 29 / 87

培训手册
Training Manual
操作前检查
Pre-operation Inspection
JCPT- DCS
www.cndingli.com
3-3

平台入口门（
Platform entry gate
）

指示灯和警报器（如果配备）（
Beacon and alarms (if equipped)
）
 安全臂（
Safety arm
）

延伸平台（
Platform extension
）
 剪叉臂销钉和紧固件（
Scissor pins and retaining fasteners
）

平台控制手柄（
Platform control joystick
）
 刹车释放部件（
Brake release components
）

坑洞保护装置（
Pothole guard
）
检查整个机器以查找：（
Check entire machine for:
）

焊缝或结构部件中的裂纹（
Cracks in welds or structural components
）
 机器的凹痕或损坏（
Dents or damage to machine
）

确保具备所有结构件和其它关键部件完整，所有相关紧固件和销钉均处于正确位置并已拧紧
（
Be sure that all structural and other critical components are present and all associated
fasteners and pins are in place and properly tightened
）

护栏已安装，护栏销安装到位，螺栓已适当拧紧。（
Be sure side rails are installed and rail
pins and bolts are fastened.
）

确保底盘电池托盘和油泵托盘已关闭并锁定，蓄电池连接正确。（
Be sure that the chassis
trays are closed and latched and the batteries are properly connected.
）
2.
工作场地检查（
Workplace Inspection
）
工作场所检查有助于操作员决定工作场所是否能保证机器安全操作。将机器移动到工作场所之前操
作员应首先进行此项工作。了解并记住工作场所的危险事项是操作员的职责，当移动、安装和操作
机器时可以留意并避免以下问题。
The workplace inspection helps the operator determine if the workplace is suitable for safe
machine operation. It should be performed by the operator prior to moving the machine to the
workplace.
It is the operator's responsibility to read and remember the workplace hazards, then watch for
and avoid them while moving, setting up and operating the machine.
当心和避免下列危险情况的出现：（
Be aware of and avoid the following hazardous situations:
）

陡坡或洞穴（
Drop-offs or holes
）
 突起物、地面障碍物或碎屑（
Bumps, floor obstructions or debris
）