Operator’s Manual
Operating Instructions
GTWY1200 SERIES 16
Emergency Stop
Push in the red Emergency Stop button at the
platform controls or at the ground controls to
stop the up/down function.
Platform Raise and Lower
1. Twist
to
release
the red Emergency Stop
buttons to the on positions at the platform
controls and at the ground controls.
2. You could move the platform by push in
the up/down switch at ground control in
the direction of intended travel. (Turn the
key switch to ground control)
3. You can also move the platform by Push
in the control activate button and rotate
the up/down switch at platform control in
the direction of intended travel. (Turn the
key switch to platform control)
Manual Lowering
1. Activate the manual lowering valve
located at the side of the hydraulic unit.
2. The platform should lower.
Fall Protection
Personal fall protection equipment (PFPE) is
not required when operating this machine. If
PFPE is required by job site or employer rules,
the following shall apply:
All PFPE must comply with applicable
governmental regulations and must be
inspected and used in accordance with the
manufacturer’s instructions.
After Each Use
1. Push in the red Emergency Stop buttons
at the platform controls and the ground
controls.
2. Remove the key to secure from
unauthorized use.
3. Turn off the circuit breaker and the power
light is out. Cut out the power and fixed
the cable.
4. Select a safe storage location—firm, level
surface, weather protected, clear of
obstruction and traffic.
5. Chock the wheels to prevent the machine
from rolling.
6. DC models: Recharge the battery.
