ULM–54
©
Dinel, s.r.o.
18
Lower range setting of the measured magnitude in the level meter
The value of the measured magnitude at which the level meter output will be at the minimum
(4 mA) is entered here.
For level meter ULM-54 using the reflex method se the data is entered in millimeters and repre
-
sents the distance of the level from the front of the ultrasonic transducer. The value is always a
floating-point decimal number.
9.1.1. Parametrization of Dinel level meters with the HART® protocol support
This part of the menu is intended only for setting the ULM-54, ULM-70, GRLM-70, and CLM-70
level meters from Dinel, s.r.o. It is not displayed when a different device is connected. The basic
settings for these probes can also be carried out in the BASIC PARAMETRIZATION. In the men
-
tioned menu, however, it is possible to set, in addition to the basic parameters, also some other
parameters that are specific for the mentioned devices.
• Menu:
MIN LEVEL
(ID 072)
•
[↔] - Movement between characters, [↕] - Increase in the value of the marked digit
(at marked decimal point, a shift by one order occurs)
008
CONFIGURATION
069
BASIC SETUP
057
HART
072
MIN LEVEL
059
DINEL DEVICE MENU
Upper range setting of the measured magnitude in the level meter
The value of the measured magnitude at which the level meter output will be at the maximum
(20 mA) is entered here.
For level meter ULM-54 the value is entered in millimetres and it represents a distance of the level
from the transducer face or from the beginning of the electrode. The value is always a floating
comma number.
• Menu:
MAX LEVEL
(ID 073)
• [
↔] - Movement between characters, [↕] - Increase in the value of the marked digit
(at marked decimal point, a shift by one order occurs)
008
CONFIGURATION
069
BASIC SETUP
057
HART
073
MAX LEVEL
059
DINEL DEVICE MENU
