7
Wall Control Installation
!
NOTE:
All electrical wiring
must comply with all national
and local electrical codes and
regulations. Always use a
qualified and licensed electri
-
cian should you have any
questions or concerns for all
wiring work.
!
NOTE:
The
Wall Switch
Remote Control
is made to
fit standard Decora style
faceplates. Due to material
inconsistencies of individual
faceplates, it may be neces-
sary to remove the faceplate
for operations such as chang-
ing batteries.
Site Selection for Installation
Although this Wall Switch Remote
Control can operate on battery
power or by hard wire installa-
tion, a convenient and accessible
location should be chosen. The
range of the Wall Switch Remote
Control is approximately 50 feet
(15 m).
Installation requires the use of a
standard device box and should
the hard wire installation method
be chosen, a location near an
available 24V~ power source
should be considered.
WARNING:
Electrocution or
other bodily harm and property
damage can occur if a live wire
is touched or damaged during
installation. Always consult
electrical schematics for the
installation location of all wir-
ing or consult a qualified and
licensed electrician before you
begin.
Installation
Required Tools and Hardware:
•
Flat head screwdriver
•
Wire cutters / strippers
•
Two (2) wire nuts for 22 AWG
wire
•
Standard wall device box with
minimum depth of 2.5 inches
(6.35 cm)
•
24V~ Power supply (for hard
wired power installation if
applicable)
Battery Powered Installation
1. Remove the Wall Switch Re-
mote Control and installation
hardware from its package.
2. Release the Controller from
its Outer Housing by pushing
the front face into the Outer
Housing until you hear a click.
This will release the push-lock
latches and allow the Control-
