13
Figure 9
Key-hole
Wall stud
Permanent
mounting hole
forward to allow the partially
reflective glass to fall out of
the inside framing.
CAUTION:
Partially reflective
glass is not tempered. Do
not bump or drop the partially
reflective glass to avoid breakage
and personal injury.
• Remove partially reflective
glass from fireplace.
4. Position the fireplace on a wall
at the position where it will be
mounted (Figure 9). Use a
bubble level (one is supplied)
to ensure that fireplace is level
on the wall.
5. Ensuring that at least two key-
holes line up with a wall stud
(key-holes are spaced at 4"
(10.2 cm) centers), mark the
Fireplace Installation
location of four screw locations
on the wall (through key-
holes).
6. Remove fireplace from wall
and store in a safe place away
from traffic.
7. Where marked screw locations
do not line up with a wall stud,
insert (screw in) one of the two
supplied wall anchors (predrill
if required). Repeat if only two
screws line up with a wall stud.
8. Screw all four supplied #8, 1½"
(3.8 cm) square head mounting
screws and washers into
the wall and/or wall anchors
leaving ¼" (6.5 mm) of thread.
9. Align chosen key-holes with
screws and hang fireplace
on the wall. Screw heads
and washers will fit through
keyholes and fireplace will
slide down into place (screws
will slide into narrow part of
keyholes).
10. Tighten all four mounting
screws down on fireplace
chassis.
11. Screw the two supplied #8
square head screws through
two of the permanent mounting
holes which align with a wall
stud.
