5
INSTALL OVERVIEW
Remove Contents
Take your components out of the box. Remove the
protective packaging. Keep track of all the parts that you
remove from the box. Remove the battery and put it on
charge.
1.
Installation
Once you have your bike ready for installation, the first
step (after transferring your rim tape, tube and tyre) is
to install the wheel and secure the axle nuts. Take note
of the order or the washers so that you can replicate
this when installing into the frame. Then move on to the
battery cradle/ controller and handlebar controls.
3.
Ride!
Once the battery is fully charged, you’ve checked your
tyre pressures and fasteners you’re now ready to go!
5.
Prepare you bike
Make sure you have measured your dropout slot
widths (approx. 10mm) and the clearance between your
dropouts (approx. 135-140mm for the rear of the frame).
Remove your current wheel, remove the tyre, tube, rim
tape and also your handlebar grips, shifters and brakes.
2.
Tidy Up
After you have installed all of the components needed to
control each part of the kit, it’s now time to tidy up the
wiring harness and make your conversion look nice and
neat.
4.