Digital Projection
E-Vision 6500 Series
A Tour Of The Menus
Operating Guide
Page 37
Rev D July 2014
Setup menu
Auto Search
•
When this is set to
On
, the projector will search for an alternative input source when the
current input source is disconnected
•
When this is set to
Off
, the projector will show the ‘background’ screen when the current
input source is disconnected.
Auto Power Off
•
Set this to
On
, if you want the projector to go into
Standby mode
when no input source
is detected for 20 minutes.
Auto Power On
•
Set this to
On
, if you want the projector to start up immediately when the mains is
connected.
•
Set this to
Off
, if you want the projector to go into
Standby mode
when the mains is
connected. In this case, the projector will not start up until the
POWER
button is pressed
on the control panel or the remote control.
Standby Mode
•
Set this to
Standard
or
Eco
as required.
MENU = END
|
SEL/ADJ.
|
SEL.
Setup
Video
Installation
Signal
Picture
Standard
On
Auto Search
Auto Power Off
Auto Power On
Standby Mode
Background
Advance Setting
Aspect Ratio
3D Mode
On
On
Logo
Normal
Notes
See also
Using the Menus
, earlier
in this guide and
Menu Map
, later in
this guide.
To set the background screen, see
the next page.
When Standby Mode is set to
Eco
:
the
Monitor Out
signal is disabled,
and the RS232 connection is
disabled, so it will not be possible
to turn the projector
On
remotely,
except via the LAN connection.
