Digital Guard Dawg 2GO KEYLESS iKEY RS, Инструкция по установке и эксплуатации

Страница: 21 / 36

21
Push Button Start
~ Accessory Harness (10-Pin)
Wire Description
1
Orange
Data Module
Trigger
This wire provides a constant 250mA positive output 1
second before the vehicle is started to activate a Data
or Bypass module
2
Red
+12V Supply
This wire is a +12v constant supply wire used to
supply power to External High Current Relays
(optional)
3
Gray
(-)
Factory security
bypass
This wire provides a constant 500mA negative output
while the vehicle is in
ACC
,
(RUN)
, and
CRANK
position. The output becomes active 0.5sec before
ACC is on, and becomes inactive when PSB
shutdown the vehicle. The output can be used to
control external relays, bypass kits, etc.
4
White
(-) Neutral
Safety input
This wire will test for a ground from the gear selector
either in PARK or NEUTRAL. This will prevent the
vehicle from accidentally being remote started while in
a drive gear.
This input MUST set at ground in
order for the remote start function to operate.
5
Purple
PBS Control
This is the input wire for receiving an
Authorization
Signal
from an option 2GO-PKE / Passive Keyless
Entry Module.
6
Pink
For “Diesel”
Vehicles
Only”
Connect this wire to the wire in the vehicle that sends
the signal to turn on the WAIT-TO-START bulb in the
dashboard. (Also known as “Glow-plug light”.) In most
diesels the wire is negative (ground turns on the bulb)
and this wire can be directly connected to the vehicle.
If the vehicle uses a positive wire (12V to turn on the
bulb) a relay must be used to change the polarity.