Digital Guard Dawg 2GO KEYLESS iKEY RS, Инструкция по установке и эксплуатации

Страница: 13 / 36

13
Negative or Positive Door Trigger
The Green wire in the 7 PIN Accessory harness is used to sense when a
vehicle door is open. It will need to be connected to your vehicle’s dome light
circuit or individual door triggers. Generally, most vehicles have an overall
signal wire which will trigger a signal no matter which door is opened. Door
triggers can be either Negative (GM and most Imports) or positively triggered
(most Fords and some Imports)
.
You can refer to your vehicle’s electrical
service manual for details on location and color coding of the Dome Light or
Door Trigger wire(s). Remember to only use a Digital Multi Meter when testing
for vehicle wires.
Three different connections may be made to determine the Vehicle’s Door
Status.
(1)
The Dome Light is a simple circuit of two wires that illuminate a bulb once
any door opens on the vehicle. Various Manufacturers also have dome lights
that do not immediately turn off once all vehicle doors are closed. In this case,
when Dome Light Delay is present, it is preferable to use an alternate means to
determine the Door Status.
(2)
Door Pin Switches are used in many vehicles and their associated wires can
be typically found in the driver’s kick panel or near the BCM. If multiple wires
are used to determine “Door Status” connections to the 2GO Keyless™ PKE
must be independently isolated to each wire to prevent damage to BCM
(Appendix B Fig 2).
(3)
Data Interfaces can also be used to determine Door Status by using the RX
and TX lines of the vehicle while the interface provides an output to the green
door status wire.