Digital Guard Dawg 2GO KEYLESS iKEY RS, Инструкция по установке и эксплуатации

Страница: 20 / 36

20
Once you have decided which type of installation is right for your vehicle. Locate the vehicle
Main Ignition switch harness. Begin by locating all Ignition and signal wires listed below and
then connect wires according the wire diagram.
Make sure to connect the Ground wire
first before making the 12-volt connections or powering up the PBS Module
Push Button Start
~ Main Harness (8-Pin)
Wire Description
1
Purple Not Used
2
White
Starter (+)
Connect to the wire going to the Start Solenoid
3
Red
( + )
12V Battery
Connect to the 12V supply wire of the Ignition harness.
Ensure that the OEM power wire is fuse is more than 15A.
Note:
certain new vehicles have no suitable 12 volts source
at the
IGNITION
switch (the 12 Volt wire is too small to
supply the necessary current). In this case, the fuse box, or
the
+
connection on the battery is recommended.
4
Blue
Ignition #2
(+)
This wire is provides a circuit that switches OFF during
starter cranking. Use for A/C or other circuits not necessary
during starting.
5 Green
Ignition #1
(+)
This wire is the primary Ignition circuit that remains ON
during starter cranking. Use to provide power to all primary
Ignition components
6
Black
Ground
( - )
This wire is the system Ground and must be connected to
bare, unpainted metal Chassis or true Body ground. It is
preferable to use a factory ground bolt rather than a self-
tapping screw.
Screws tend to get loose or rusted over
time and can cause erratic problems.
7
Red
+12V Battery
Connect to the 12V supply wire of the Ignition harness.
Ensure that the OEM power wire is fuse is more than 15A.
8
Yellow/Green
Accessory #1
(+)
This wire provides power to vehicle Accessories such as
radio and climate control fan. This circuit also switches OFF
during Starter cranking but is able to be independently
switched ON as “Accessory Only” mode