Digital Equipment VNswitch 900FF, Руководство по установке и настройке

Страница: 36 / 100

Module Components
3-4 Installing the DIGITAL VNswitch 900FF
Item Icon Name Description
8 Reset/Dump
Button Used to either reset the module or cause an
upline dump of the operational image,
followed by a reset. If this button is
pressed as operational code initializes, the
module resets to current settings.
If the module is in operation mode, hold
the button for five seconds. Use a non-
conductive device to press the button.
9 Address
Label Contains the lowest of 256 consecutive
Media Access Control (MAC)
addresses.
10 Port Status
LEDs Shows the status of the Mod-FDDI card
A/M or B/S ports. Indicates if the port is
enabled or disabled and receiving a valid
link.
Port Activity
LEDs Indicates network traffic level.
11 Mod-FDDI
card slots Supports installation of Mod-FDDI cards.
The Mod-FDDI cards are customer
installable and hot swapable. The top slot
is labeled A/M. The bottom slot is labeled
B/S. In a dual ring or a treed topology, the
top port is the M port and the bottom port
is the S port.