Digital Equipment VNswitch 900FF, Руководство по установке и настройке

Страница: 52 / 100

Assigning an IP Address
5-2 Configuring the Module in a DEChub ONE
Assigning an IP Address
After installing the module in a DEChub ONE docking station, connecting the cables,
and assigning an IP address, you need to configure the module. Do this using one of
the following methods:
•
A Telnet session to access the command line interface
•
Through the command line interface, which is accessed through a terminal
connected to the setup port on the DEChub ONE docking station
•
Through clearVISN MultiChassis Manager
The setup port provides menus that allow you to access the VNswitch 900FF. These
menus allow you to set up the module for basic connectivity. After setup, you can
configure the module’s software using commands. You can access these commands
remotely via TCP/IP Telnet, or locally through the setup port on a DEChub ONE
docking station.
To perform a Telnet session, you must assign an IP address. To do this, complete the
following steps:
Step Action
1
Install the module into the DEChub ONE docking station.
2
Select the IP Configuration option from the menu.
3 Set the in-band IP address.
4
Set the default gateway, if necessary.
5
Return to the
VNswitch 900FF INSTALLATION MENU
and select
[2] Restart with Current Settings
.
6 Open a Telnet session into the module from the management station for
further configuration.
To access the configuration menus, press Return on the setup port
device until the
VNswitch 900FF INSTALLATION MENU
appears.
For further configuration information, refer to DIGITAL VNswitch 900
Series Switch Management.