Hybrid Plug-In Guide
34
Graphic Editing of LFOs
The LFO section provides two graphic controls
in its display for changing LFO Phase and LFO
Rate.
To adjust the LFO Rate, do one of the following:
Drag the LFO Rate cursor above the waveform
display left to increase the rate. The increasing
numbers of displayed wave cycles indicate the
higher speed of the LFO.
– or –
Drag the LFO Rate cursor above the waveform
display right to decrease the rate. The decreasing
numbers of displayed wave cycles indicate the
lower speed of the LFO.
To adjust the phase of the LFO:
1
Select a mode from the Sync mode pop-up
menu to activate LFO synchronization.
2
Adjust the LFO phase by clicking and dragging
the LFO Phase control horizontally or vertically.
The LFO Phase control indicates the starting an-
gle of the LFO.
LFO Synchronization
The LFOs have six different Synchronization
modes to determine how rate and phase re-
spond to your play on the keyboard, the tempo
of the song, or the internal step sequencer. This
way the modulation can be matched to an enve-
lope sweep, the beat of the song or a sequencer
phrase.
When the Sync mode is set to Off, the LFO is
freely running. Choose a mode from the pop-up
list to activate LFO synchronization and bring
Sync mode and the Phase control into effect.
Depending on the mode, the rate display
switches from values in Hertz (Hz) when freely
running to values in note length or multiples of
step sequencer steps when running synchro-
nized. The six modes work as follows:
Off
The LFO is freely running with the frequency
set by the Rate control. Values display in units of
Hertz or seconds.
First Note
The LFO restarts when a note is
played while no other notes are held. The rate
parameter indicates values in units of Hertz or
seconds. Use this method to synchronize the
modulation to an envelope sweep.
Each Note
The LFO restarts whenever a note is
played. The rate parameter indicates values in
units of Hertz or seconds. Use this method to
synchronize the modulation to an envelope
sweep.
Step Seq
The LFO restarts with Hybrid’s step
sequencer. The LFO rate specifies in multiples of
step sequencer steps. Use this method to
produce sweeps that match the length of a
sequencer phrase.
Adjusting LFO rate
Adjusting LFO phase
LFO Rate cursor
LFO Phase control
Содержание Hybrid
