IPsec parameters
Digi TransPort User Guide
394
IPsec parameters
IPsec (Internet Protocol security) refers to a group of protocols and standards that may be used
to protect data during transmission over the internet (which is inherently insecure). Various levels
of support for IPsec can be provided on the router depending on the model. The web pages
located under the
Configuration > Network > Virtual Private Networking (VPN) > IPsec
are
used to set the various parameters and options that are available. You should note however that
this is a complex area and you should have a good understanding of user authentication and
data encryption techniques before you commence. For further information refer to the IPsec and
VPNs section in this manual. Also check the Technical Notes section of the Digi International web
site at
www.digi.com
for the latest IPsec application notes.
The first stage in establishing a secure link between two endpoints on an IP network is for those
two points to securely exchange a little information about each other. This enables the endpoint
responding to the request to decide whether it wishes to enter a secure dialogue with the
endpoint requesting it. To achieve this, the two endpoints commonly identify themselves and
verify the identity of the other party. They must do this in a secure manner so that the process
cannot be listened in to by any third party. The IKE protocol is used to perform this checking and
if everything matches up it creates a Security Association (SA) between the two endpoints,
normally one for data being sent
to
the remote end and one for data being received
from
it.
Once this initial association exists the two devices can talk securely about and exchange
information on what kind of security protocols they would like to use to establish a secure data
link, such as what sort of encryption and/or authentication they can use and what sources/
destinations they will accept. When this second stage is complete (and provided that both
systems have agreed what they will do), IPSec will have set up its own Security Associations which
it uses to test incoming and outgoing data packets for eligibility and perform security operations
on before passing them down or relaying them from the tunnel.
Содержание TransPort
