5. LEIT RC2ET remote control handset (version SW
U:1.XX.XX EE 1.XX.XX) to communicate with up to
99 LEIT-2ET controllers.
6. LEIT WWS or LEIT WWSE ambient light (solar) powered wireless weather
station used to transmit weather
data to the LEIT-2ET controller.
1.3 Tools and Supply Requirements
1. Standard wire stripper.
2. Phillips screwdriver (#1) if using the valve clip attachment or the mounting
column plastic attachment, or Phillips screwdriver (#2) if using the valve box
mounting dome.
3. Concrete: approximately one (1) 90 lb (40 kg) bag, if using the mounting
column installation.
4.
WATERPROOF WIRE CONNECTORS
(not included).
1.4 Quick Installation Setup and Operation Review
In order to establish communication for the first time between a LEIT RC2ET
handset and LEIT-2ET two station weather based, ambient light (solar)
powered wireless irrigation controller and the LEIT WWS or LEIT WWSE
weather station, the following steps must be taken:
1. Charge the LEIT RC2ET handset (see LEIT RC2ET instructions).
2. Set up the LEIT RC2ET handset (see LEIT RC2ET instructions).
3. Install the LEIT-2ET controller following the LEIT-2ET installation
instructions, see Section 2, then set it out in the light for initial charge.
4. Install the LEIT WWS (with wind sensor) or LEIT WWSE (without wind
sensor) weather station following the installation instructions inside each
box and allow the controller and weather station to harness light energy.
After the weather station has been installed, no wire connection or
programming is required for the unit’s operation.
10
