Horizontal-Schrumpfgerät
Horizontal Shrinking Device
HS 1100-P
BA_79-E.docx
Copyright © Diebold 2017-04 Ersteller: kh
Seite 37 von 60
16.4.
Avoid overheating “ThermoGrip” Chucks
The chuck and tool can overheat as a result of incorrectly entered shrink parameters
and repeated heating of a “ThermoGrip” chuck in a short period of time. This is why the
shrink parameters must be entered with particular care. Use a lower setting if in doubt.
Repeated heating the chuck is to be avoided. Before heating chucks again, make sure
to cool it down to room temperature first.
Avoid the use of excessive shrinking energy and long shrink times.
Do not keep flammable substances in the vicinity of the unit.
Do not use flammable cleaning agents.
16.5.
Hazards from electromagnetic radiation
When the unit is used properly, there is no magnetic radiation to the immediate
surroundings. The radiation safety of the unit has been tested and verified by
EN 55011:2007+A2:2007 category A group 2. If the Inductive heating is started up
without a tool holder in the coil, the magnetic field affects only the immediate vicinity of
the coil.
For your own safety, please comply with the following rules:
Do not run any other units into the vicinity of the unit to avoid electrical
interference.
If you have a cardiac pacemaker, please consult the manufacturer or
your doctor. In certain cases, interference is possible.
