DIEBOLD NIXDORF CINEO C1010, Руководство пользователя

Страница: 55 / 69

CINEO C1010 Malfunctions
49 _
ccTalk error
code
Description/Cause Category Remedy/hints By whom
sorting spiral", p. 31)
0x0AFCnn Communication error between
coin validator and main PCB Critical Open lid
(cf. Chap. "Opening and closing
the CINEO C1010 lid", p. 20) and check
connections of 10-pole and 20-pole
cables on motor PCB, then open payout
unit
(cf. Chap. "Opening and closing the
coin payout unit", p.21) and check con-
nection of 20-pole cable on main PCB and
connection of 10-pole cable on coin
validator PCB
Service
0x0AFEF0 Configuration data block
upload successful Info
0x0AFEF1 Configuration data block
upload not successful Critical Repeat upload Service
0x0AFEF4 Cleaning cycle started Info
0x0AFEF5 Cleaning cycle stopped Info
0x0AFF.. Unknown/other error
0x0B01 Coin return belt motor failure.
Return belt motor was com-
manded to operate but no
current flow through the
motor was detected Critical Make sure that the return belt and its
motor are installed and connected cor-
rectly
If necessary, replace return belt incl.
motor
Service
Service
0x0B02
Coin return belt motor over-
current likely due to coin jam
Attention
Eliminate coin jam or foreign objects on
the return belt Attendant possessing the
key for the lower lock
0x0E65 Coin input funnel communica-
tion failure. CINEO C1010
control unit was unable to
establish communication with
the input funnel Critical Make sure that the coin input funnel is
installed/connected correctly
(cf. Ser-
vice Manual)
If necessary, replace coin input funnel
(cf.
Service Manual)
Service
Service
0x0E66
Coin input funnel replied with
NACK status code after send-
ing user interface a command
Info
0x0E67 Coin input funnel replied with
BUSY status code after sending
user interface a command Info
0x0E68 Coin input funnel replied with
wrong checksum Info
0x0E69 Coin input funnel replied with
unknown command Info
0x0E6A
Coin input funnel replied with
not allowed
Info